OTR Step Deck Driver Jobs in North Dakota — Now Hiring

What does a step deck driver actually haul?

A step deck — also called a drop deck — is a flatbed with two levels: a short upper deck over the tractor and a longer lower deck that sits about eighteen inches closer to the road. That drop is the entire point. A standard flatbed can legally carry freight about 8 feet 6 inches tall before it needs an oversize permit; the lower deck of a step deck takes roughly 10 feet 2 inches of the same freight with no permit, no escort and no route survey. Drivers haul excavators, agricultural equipment, HVAC units, tanks, and machinery that is simply too tall to ride on a standard deck. The securement work is flatbed work — chains, binders, straps and tarps — with ramps and a deck transition added to it.

You arrive at an equipment dealership outside Fort Worth just after seven. In the yard sits a mid-size excavator, about 9 feet 4 inches tall on its tracks. On a standard flatbed that is a permit load. On your lower deck it is legal freight, and that difference is why the dealer called a step deck. The yard hand walks the machine up your ramps while you stand clear and watch the tracks find the deck edge. Once it is centred, the real work starts. Heavy machinery has its own securement rule: four separate tiedowns, each one attached to a manufacturer-marked point on the machine, and the boom and bucket secured on their own because they are accessories that can move independently. You lower the bucket to the deck, chain it, then run four 3/8-inch Grade 70 chains from the frame points to the winches on your rails. Each chain gets a binder and a second pass to check for slack. Before you pull out you measure your height. Deck height plus machine height comes to 12 feet 8 inches overall — under the 13 feet 6 inches most routes assume, so you are legal, but you note the number and check it against the two low bridges on your route north. The run is 340 miles to a job site in Oklahoma. Fifty miles out you pull into a rest area and re-check every chain, because tracked machinery settles on its rubber pads and chains loosen. Two need a quarter turn. At the site the operator backs the excavator down the ramps while you pull chains, and by early afternoon you are empty and looking at a load of HVAC units — tall, light, and needing tarps — for the run back.

Full step deck driver guide — top carriers, endorsements and career path

Where in North Dakota would you actually be running?

Freight here moves on a handful of named lanes. These are the ones a step deck seat domiciled in Williston is most likely to see.

• Fargo: I-94, I-29 — Agriculture (Sugar Beets, Wheat) and Oil Field Services (Bakken) freight.
• Bismarck: I-94, US-83, US-83 — Government and Healthcare freight.

What does this step deck seat pay in North Dakota?

The band on this posting is $66,500 - $94,000/year. Where you land inside it comes down to verifiable experience, the lane you take, and your safety record.

For context, the statewide CDL-A average is $63,330. Wages here are stable — North Dakota wages remain elevated compared to the state's low cost of living, driven by Bakken oil field hauling in western ND. Williston-area drivers earn significant premiums for energy sector work.

North Dakota runs a cost-of-living index of 92, so this band is worth roughly $68,837 once living costs are taken out. That number is what to compare against an offer in another state.

• Strongest-paying metros in North Dakota:
• Williston
• Fargo — about $63,330
• Bismarck — about $60,797

North Dakota CDL pay breakdown by experience level and equipment

What do you need to qualify?

• Valid CDL-A license
• DOT medical card
• Working knowledge of FMCSA cargo securement rules (393.100-136), including the rules specific to heavy machinery
• Comfort loading and unloading over ramps — much of this freight drives on and off under its own power
• Physical fitness for tarping, chaining and climbing on and off two deck heights
• Most carriers want 6-12 months of flatbed or tractor-trailer experience before putting a driver on a step deck

Is step deck work worth it?

What drivers who stay in this segment say they like about it:

• Pays above standard flatbed for the same licence — the premium comes from the securement skill, not from extra miles
• Taller freight without permits means fewer route restrictions and fewer curfews than an oversize load
• Machinery and equipment freight holds up when dry van volume softens, because it follows construction and agriculture rather than retail
• Loading is usually at yards, dealerships and job sites rather than a dock, so there is far less waiting

What is the hardest part of this job?

We would rather you know now than quit in week three.

• All of flatbed's physical demands plus ramps — driving a machine up a ramp onto a deck is unforgiving of mistakes
• Two deck heights complicate securement: freight on the upper deck needs different tiedown geometry than the same item on the lower deck
• Height still has a ceiling — go past roughly 10 feet 2 inches of cargo and you are back into permits, which means an RGN or a lowboy instead
• Weather exposure is constant, and a tarp thrown over a machine on a lower deck is awkward work in wind

What should a step deck driver know before running North Dakota?

Speed limits for trucks in North Dakota run 75 mph (same as cars). Rural: 75 mph. Tolls: No toll roads in the state.

Fuel tax in North Dakota is $0.23 per gallon diesel + federal, which matters if you are comparing per-mile offers across state lines. Inspection climate: High in oil field areas. ND Highway Patrol focuses heavily on Bakken region truck safety. I-94 corridor sees routine enforcement.

Which North Dakota rules catch step deck drivers out?

• Gross weight limit: 105,500 lbs on state routes with permit
• Axle weight: 20,000 lbs single axle, 34,000 lbs tandem
• Truck speed limits: 75 mph rural, 55 mph urban
• Diesel fuel tax: $0.23 per gallon diesel + federal
• Tolls: No toll roads in the state.
• Inspection posture: High in oil field areas. ND Highway Patrol focuses heavily on Bakken region truck safety. I-94 corridor sees routine enforcement.
• North Dakota allows 105,500 lbs on state routes for the oil and agricultural industries
• Bakken oil field generates enormous truck traffic in western ND
• Severe winter blizzards can strand trucks for days

All North Dakota driving jobs and state regulations

How does applying through us work?

1. 1You send the short form on this page. It takes under a minute and needs no resume.
2. 2A recruiter reads it and calls you — a real person, not an automated screen.
3. 3We match you against the over-the-road step deck openings our client carriers have right now, including ones never posted publicly.
4. 4You choose which to interview for. Nothing is submitted anywhere without you saying yes.
5. 5There is no cost to you at any point. Carriers pay us, drivers never do.

Are these jobs actually live?

Yes — and it is a fair thing to ask, because plenty of driver postings are not.

Ahmad Qazi, sales representative at TruckingJobsInUSA: “Carriers have filled seats through this platform, and the owners we place drivers with are straightforward to deal with. If a seat is gone, we take the posting down rather than leave it up to collect applications.”

Every posting on this site is republished on the date shown, so what you are reading is current recruitment, not an archive.